- Branża: Electrical equipment
- Number of terms: 4774
- Number of blossaries: 0
- Company Profile:
In order to reduce wear and avoid overheating certain motor components require lubricating (application of an oil or grease). The bearings are the major motor component requiring lubrication (as per manufacturer's instructions). Excess greasing can however damage the windings and internal switches, etc. (See PLS)
Industry:Electrical equipment
It is a fundamental principle of a winding that adjacent poles must be wound to give opposite magnetic polarity. This does not mean that the coils actually have to be wound in this direction before being placed into the stator. It does mean that the winding must be connected so that, if the current proceeds through one pole in a clockwise direction, it must proceed through the next pole in a counterclockwise direction. This principle is used to determine the correctness of connection diagrams.
Industry:Electrical equipment
A device that takes electrical energy and converts it into mechanical energy to turn a shaft.
Industry:Electrical equipment
When two or more DC motors are required to operate in parallel - that is, to drive a common load while sharing the load equally among all motors - they should have speed-torque characteristics which are identical. The greater the speed droop with load, the easier it becomes to parallel motors successfully. It follows that series motors will operate in parallel easier than any other type. Compound motors, which also have drooping speed characteristics (high regulation), will generally parallel without special circuits or equalization. It may be difficult to operate shunt or stabilized-shunt motors in parallel because of their nearly constant speed characteristics. Modifications to the motor control must sometimes be made before these motors will parallel within satisfactory limits.
Industry:Electrical equipment
Indicates the space relationships of windings and changing values of the recurring cycles of A.C. voltages and currents. Due to the positioning (or the phase relationship) of the windings, the various voltages and currents will not be similar in all aspects at any given instant. Each winding will lead or lag another, in position. Each voltage will lead or lag another voltage, in time. Each current will lead or lag another current, in time. The most common power supplies are either single (10) or three phase (with 120 electrical degrees between the 3 phases).
Industry:Electrical equipment
Two or three-phase induction motors have their windings, one for each phase, evenly divided by the same number of electrical degrees. Reversal of the two-phase motor is accomplished by reversing the current through either winding. Reversal of a three-phase motor is accomplished by interchanging any two of its connections to the line. Polyphase motors are used where a polyphase (3-phase) power supply is available and is limited primarily to industrial applications.
Starting and reversing torque characteristics of polyphase motors are exceptionally good. This is due to the fact that the different windings are identical and, unlike the capacitor motor, the currents are balanced. They have an ideal phase relation which results in a true rotating field over the full range of operation from locked rotor to full speed.
Industry:Electrical equipment
A measurement of the time phase difference between the voltage and current in an AC circuit. It is represented by the cosine of the angle of this phase difference. For an angle of 0 degrees, the power factor is 100% and the volt/amperes of the circuit are equal to the watts. (This is the ideal and an unrealistic situation.) Power factor is the ratio of Real Power-KW to total KVA or the ratio of actual power (watts) to apparent power (volt-amperes).
Industry:Electrical equipment
A relay, the principal function of which is to protect service from interruption, or to prevent or limit damage to apparatus.
Industry:Electrical equipment
A device that is operative by a variation in the conditions of one electric circuit to effect the operation of other devices in the same or another electric circuit.
Industry:Electrical equipment
The degree of obstacle presented by a material to the flow of electric current is known as resistance and is measured in ohms.
Industry:Electrical equipment
